Philips Signage Solutions Display (Android 4.0)

💡 This is information for setting up and using equipment for PinToMind. Although we have an instruction, it is not a recommendation. Find information about equipment we recommend, on our website.

⚠️ This instruction is for Philips Signage Solution screens of the types D-Line, Q-Line and P-Line with model code 4050. Eg. 65BDL4050D. Common to these is that they run Android 4.4.4 and were produced until 2020.

Start-up of a new screen

  • Hang the screen, connect to electricity and follow the steps for start-up and internet-connection.
  • Choices regarding configuring CMS, CMND etc. are not needed.

You can reset to factory settings if you want to start set-up again. See more information below.

Start display in browser


1. Click SOURCE on the remote.

2. Select "Browser"

3. Click on "Settings" under "Browser"

4. Enter the address https://app.pintomind.com/live/ and click ”OK”.

(If https:// doesn't work on your screen model, try http:// or without https://)

5. Select the address in the list by pressing "OK" on the remote control at the address. Confirm once more.

6. Open https://app.pintomind.com/live/ in the browser. The screen now displays a code and instructions.

7. On another computer or mobile: Log in to app.pintomind.com/connect, and enter the code on the screen to connect the device to your account. 

8. Select which screen to display on the device under "SELECT A SCREEN". 

You can change the screen displayed on this device, at any time. See info here.

9. The screen you selected now starts displaying on your device.

That's it! 😊

Set up automatic start in browser

  • Click on ⌂ HOME on the remote
  • Select "Configuration 1" -> "Start on source".
  • Select "Entrance" ◀ BROWSER ▶ and "Playlist: ◀ 1 ▶"
  • The screen will then automatically start up again when the browser is turned on..

Set timing

  • Click on ⌂ HOME on the remote
  • Select "Advanced" -> "Schedule" and add times for on and off.

Reset Philips D-line to factory settings

NB! This guide will delete all content and settings on the screen.

  • Click on ⌂ HOME, and then 1, 8, 8, 8 on the remote to open managed mode
  • Select "Settings".
  • In the list, click on "System tools" -> "Reset to factory settings" -> "Reset to factory settings"
  • Then you will get a question regarding if you want to reset, click "OK".
  • The screen will then delete all content, and start up anew.

Questions? Contact us at support@pintomind.com.